Human AN1-type zinc finger protein 6 (ZFAND6) ELISA Kit

The deduced 208-amino acid AWP1 protein has a calculated molecular mass of 22.56 kD and shares approximately 55% sequence homology with mouse Awp1 and human ZNF216. AWP1 has 2 conserved zinc finger domains: ZFA20 at its N terminus and ZFAN1 at its C terminus. It contains 2 potential PEST sequences, 4 putative N-glycosylation sites, 7 casein kinase II phosphorylation sites, and 2 N-myristoylation sites. It has a putative nuclear localization signal, but no N-terminal signal peptide, transmembrane domain, or endoplasmic reticulum retention or membrane retention motifs. Northern blot analysis detected ubiquitous expression of a 1.5-kb transcript in all tissues examined, with relatively high levels in heart, skeletal muscle, liver, kidney, and placenta.

The product listed herein is for research use only and is not intended for use in human or clinical diagnosis. Suggested applications of our products are not recommendations to use our products in violation of any patent or as a license. We cannot be responsible for patent infringements or other violations that may occur with the use of this product.

Human AN1-type zinc finger protein 6 (ZFAND6) ELISA Kit has high sensitivity and excellent specificity for detection of Human ZFAND6. No significant cross-reactivity or interference between Human ZFAND6 and analogues was observed.

This Human AN1-type zinc finger protein 6 (ZFAND6) ELISA Kit employs a two-site sandwich ELISA to quantitate ZFAND6 in samples. An antibody specific for ZFAND6 has been pre-coated onto a microplate. Standards and samples are pipetted into the wells and anyZFAND6 present is bound by the immobilized antibody. After removing any unbound substances, a biotin-conjugated antibody specific for ZFAND6 is added to the wells. After washing, Streptavidin conjugated Horseradish Peroxidase (HRP) is added to the wells. Following a wash to remove any unbound avidin-enzyme reagent, a substrate solution is added to the wells and color develops in proportion to the amount of ZFAND6 bound in the initial step. The color development is stopped and the intensity of the color is measured.

• Do not mix components from different kit lots or use reagents beyond the kit expiration date.• Allow all reagents to warm to room temperature for at least 30 minutes before opening.• Pre-rinse the pipet tip with reagent, use fresh pipet tips for each sample, standard and reagent to avoid contamination.• Unused wells must be kept desiccated at 4 °C in the sealed bag provided.• Mix Thoroughly is very important for the result. It is recommended using low frequency oscillator or slight hand shaking every 10 minutes.• It is recommended that all samples and standards be assayed in duplicate or triplicate.